I bought an L shaped dental pick from her, carefully sharpened it up and it turned out to be the best scriber I ever used for panel lines. My local flea market has a vendor who sells lots of dental tools for cheap. You can also put the surgical tubing over the ends of spring clothes pins for the same reason. Soldering Jig Surface Mount Soldering Soldering Pins Solder Removing Tool. I solved that problem by sliting a clear surgical tube longways and sliding it over the clyindrical clamping edge of the binder clip. The alligator clips fixed with screws and can be rotated 360 degrees, it is. Pic 2 -The jig can also be used to hold objects or a camera as an aid in macro-photography. A plastic bag can cover the jig with just the pins sticking through. they don't seem to stay ,put popping off the model. Pins or nails can be used to support objects in the arms while they are spray painted top and bottom. When I need to use metal binder clips for wing edges etc. you can wrap it around the fs as tight as you want and it stays there and conforms to any shape.much easier to put on and off than rubber bands. I took it off my arm and tried wraping around the fs I was working on and voila, it worked like a charm and I get it free. I use "self sticking " Ace bandage for fuselage clamps and other usage.īeing old I have regular blood tests done and the nurse always attaches the cotton ball at the needle site with this stuff clear around my arm. And all for the price of an old wire hanger in the closet and a bit of epoxy putty! :) I've also used this method to make scribers, holders, glue loops, and various other tiny tools for working with and all are custom made for what *I* need them to do. The other end is a flat drowel with a sharp tip for doing detail work. One tool I use all the time has a small elongated spoon wit ha sharp edge that is great for smoothing out putty. BST-168K Clamp Soldering Helping Hands Tool PCB Board Holder Jig Fixture Stand 2 Metal Flexible Arm Alligator Clip. Makes a great tool that I can use over and over again for just about any purpose. I take two of the wires that I fabricated and roll some epoxie putty into a handle and stick two wires in both ends and smooth it out and let it dry. Then I use a Dremel to shape and grind the pounded end to a desired shape. clamps, clothespins, your elbows, and stacks of books, most hobbyists eventually buy a helping hands jig (shown on the right of Figure A-14). I cut a length of wire (maybe 4-5 inches) and then take it outside and pound one end flat with a hammer on concrete. I do alot of epoxy putty work and instead of spending a load of cash on specialized tools, I create my own using coat hanger wire.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |